ALLIED TELESYN, INC. AT-MX300TX Device Type Transceiver NIC Type Ethernet Maximum Onboard Memory Unidentified Boot ROM Not available Network Transfer Rate 10/100Mbps Topology Star Wiring Type Unshielded Twisted Pair Data Bus External [Image] CONNECTIONS Function Label Function Label 40-pin MII interface CN1 UTP connector (RJ-45) CN2 BASE I/O ADDRESS SELECTION Note: A total of 32 base address settings are available. The switches are a binary representation of the decimal memory addresses. SW1/1 is the Most Significant Bit and switch SW1/5 is the Least Significant Bit. The switches decimal values are unidentified. (Off=1, On=0) DIAGNOSTIC LED(S) LED Color Status Condition PWR Unidentified On Power is on PWR Unidentified Off Power is off FD Unidentified On 100Mbps: Transciever in full duplex mode 10Mbps: UTP receive data signals are correctly connected FD Unidentified Off 100Mbps: Transciever not in full duplex mode 10Mbps: UTP receive data signals are not correctly connected LNK Unidentified On Network connection is good LNK Unidentified Off Network connection is broken TX Unidentified On Data is being transmitted TX Unidentified Off Data is not being transmitted RX Unidentified On Data is being received RX Unidentified Off Data is not being received COL Unidentified On Collision detected on network COL Unidentified Off No collision detected on network 100M Unidentified On Transceiver is in 100Mbps mode 100M Unidentified Off Transceiver is in 10Mbps mode